| Assay Method Information | |
| | BACE-2 Assay |
| Description: | Inhibitor IC50s, at purified human autoBACE-2 are determined in a time-resolved endpoint proteolysis assay that measures hydrolysis of the QSY7-EISEVNLDAEFC-Eu-amide FRET peptide substrate (BACE-HTRF assay). BACE-mediated hydrolysis of this peptide results in an increase in relative fluorescence (RFU) at 620 nm after excitation with 320 nm light. Inhibitor compounds, prepared at 3× the desired final concentration in 1× BACE assay buffer (20 mM sodium acetate pH 5.0, 10% glycerol, 0.1% Brij-35) supplemented with 7.5% DMSO are pre-incubated with an equal volume of autoBACE-2 enzyme diluted in 1×BACE assay buffer (final enzyme concentration 1 nM) in black 384-well NUNC plates for 30 minutes at 30° C. The assay is initiated by addition of an equal volume of the QSY7-EISEVNLDAEFC-Eu-amide substrate (200 nM final concentration, Km=8 μM for 4 μM for autoBACE-2) prepared in 1×BACE assay buffer supplemented with 7.5% DMSO and incubated for 90 minutes at 30° C. DMSO is present at 5% final concentration in the assay. Following laser excitation of sample wells at 320 nm, the fluorescence signal at 620 nm is collected for 400 ms following a 50 μs delay on a RUBYstar HTRF plate reader (BMG Labtechnologies). Raw RFU data is normalized to maximum (1.0 nM BACE/DMSO) and minimum (no enzyme/DMSO) RFU values. IC50 values are determined by nonlinear regression analysis (sigmoidal dose response, variable slope) of percent inhibition data with minimum and maximum values set to 0 and 100 percent respectively. Similar IC50s are obtained when using raw RFU data. The Ki values are calculated from the IC50 using the Cheng-Prusoff equation. |
| Affinity data for this assay | |
|---|---|
| If you find an error in this entry please send us an E-mail | |