| Assay Method Information | |
| | Electrophysiology Assay |
| Description: | Cells: The hNav1.7 expressing HEK-293 cells were plated on 35 mm culture dishes pre-coated with poly-D-lysine in standard DMEM culture media (Mediatech, Inc., Herndon, Va.) and incubated in a 5% CO2 incubator at 37° C. CuItured cells were used approximately 12-48 h after plating.Electrophysiology: On the day of experimentation, the 35 mm dish was placed on the stage of an inverted microscope equipped with a perfusion system that continuously perfuses the culture dish with fresh recording media. A gravity driven superfusion system was used to apply test solutions directly to the cell under evaluation. This system consists of an array of glass pipette glass connected to a motorized horizontal translator. The outlet of the shooter was positioned approximately 100 μm from the cell of interest.Whole cell currents were recorded using the whole-cell patch clamp configuration using an Axopatch 200B amplifier (Axon Instruments, Foster City Calif.), 1322A A/D converter (Axon Instruments) and pClamp software (v. 8; Axon Instruments) and stored on a personal computer. Gigaseals were formed and the whole-cell configuration was established in voltage clamp mode, and membrane currents generated by hNav1.7 were recorded in gap-free mode. Borosilicate glass pipettes have resistance values between 1.5 and 2.0 MΩ when filled with pipette solution and series resistance (<5 MΩ) was compensated 75-80%. Signals were sampled at 50 kHz and low pass filtered at 3 kHz.Voltage Protocols: After establishing the whole-cell configuration in voltage clamp mode, two voltage protocols were run to establish: 1) the holding potential; and 2) the test potential for each cell. |
| Affinity data for this assay | |
|---|---|
| If you find an error in this entry please send us an E-mail | |