| Assay Method Information | |
| | HTRF In vitro Profiling Assay |
| Description: | PI3Kinase Reaction Buffer was prepared by diluting the stock 1:4 with de-ionized water. Freshly prepared DTT was added at a final concentration of 5 mM on the day of use. Enzyme addition and compound pre-incubation were initiated by the addition of 2.5 μL of PI3K (at twice its final concentration) in 1× reaction buffer to all wells using a Multidrop Combi. Plates were incubated at room temperature for 15 minutes. Reactions were initiated by addition of 2.5 μL of 2× substrate solution (PIP2 and ATP in IX reaction buffer) using a Multidrop Combi. Plates were incubated at room temperature for one hour. Reactions were quenched by the addition of 2.5 μL of stop solution (Stop A and Stop B pre-mixed at a ratio of 5:1, respectively) to all wells using the Multidrop Combi. The quenched reactions were then processed to detect product formation by adding 2.5 μL of Detection Solution to all wells using the Multidrop Combi (Detection mix C, Detection mix A, and Detection mix B combined together in an 18:1:1 ratio, i.e.: for a 6000 μL total volume, mix 5400 μL Detection mix C, 300 μL Detection mix A, and 300 μL Detection mix B. Note: this solution should be prepared 2 hours prior to use). Following a one hour incubation in the dark, the HTRF signal was measured on the Envision plate reader set for 330 nm excitation and dual emission detection at 620 nm (Eu) and 665 nm (APC). |
| Affinity data for this assay | |
|---|---|
| If you find an error in this entry please send us an E-mail | |